Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

DTC    C2191/91    Vehicle Speed Signal Error (Test Mode DTC)

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU receives a vehicle speed signal from the combination meter. This DTC is stored upon entering test mode, and cleared when a vehicle speed signal of 20 km/h (12 mph) is detected for 3 seconds or more. This DTC is output only in test mode.

DTC No.
DTC Detection Condition
Trouble Area
C2191/91
Test mode procedure is performed
  1. Combination meter
  2. Vehicle speed sensor
  3. Wire harness or connector
  4. Tire pressure warning ECU

WIRING DIAGRAM


E164823E07


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU if the ECU has been replaced.

1.READ VALUE USING TECHSTREAM (VEHICLE SPEED)
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

  1. Check that the values indicated on the Techstream and on the combination meter are the same.

    Tire Pressure Monitor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Vehicle speed/
    min.: 0 km/h (0 mph)
    max.: 255 km/h (158 mph)
    Almost same as actual vehicle speed
    Speed indicated on combination meter

    OK:
    Vehicle speed indicated on the Techstream and on the combination meter are the same.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.INSPECT TIRE PRESSURE WARNING ECU (SPD SIGNAL)


    C162301E42
  1. Disconnect the L4 ECU connector.

  1. Jack up the vehicle.

  1. Move the shift lever to N.

  1. Turn the power switch on (IG).

  1. Check the waveform of the ECU connector using an oscilloscope while turning the wheel slowly.

    OK:
    Tester Connection
    Switch Condition
    Specified Condition
    L4-2 (SPD) - L4-9 (GND)
    Power switch on (IG)
    Correct waveform appears as shown

    Text in Illustration 
    *1
    Rear view of wire harness connector
    (to Tire Pressure Warning ECU)
    Tool Setting 
    Item
    Contents
    Tool Setting
    5 V/DIV., 20 ms/DIV.
    Vehicle Condition
    Driving wheels rotating slowly

    HINT:
    The wavelength becomes shorter as the vehicle speed increases.



NG
Go to step 3
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)  

3.CHECK HARNESS AND CONNECTOR (ECU - COMBINATION METER)
  1. Disconnect the L4 ECU connector.

  1. Disconnect the L27 meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L4-2 (SPD) - L27-7 (+S)
    Always
    Below 1 Ω
    L4-2 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MATER CIRCUIT PLATE NO.3 (Click here)