Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

DTC    C2196/96    RSSI Signal Error (Test Mode DTC)

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU receives a RSSI signal from the tire pressure warning antenna and receiver. This DTC is stored upon entering test mode, and cleared when an RSSI signal between 49 mV and 4.95 V is received for 3 seconds or more.

DTC No.
DTC Detection Condition
Trouble Area
C2196/96
Test mode procedure is performed
  1. Tire pressure warning antenna and receiver
  2. Wire harness or connector
  3. Tire pressure warning ECU

WIRING DIAGRAM


C210273E03


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU if the ECU has been replaced.

1.CHECK OUTPUT DTC (DTCs C2121/21 to C2124/24)
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.

  1. Read the DTCs.

    Result:
    Result
    Proceed to
    DTCs C2121/21 to C2124/24 are not output
    A
    DTCs C2121/21 to C2124/24 are output
    B



B
GO TO DTCs C2121/21 to C2124/24 (Click here)
A


2.INSPECT TIRE PRESSURE WARNING ECU (RSSI SIGNAL)


    C210275E02
  1. Disconnect the L4 ECU connector.

  1. Turn the power switch on (IG).

  1. Check the waveform of the ECU connector using an oscilloscope while idling the engine.

    OK:
    Tester Connection
    Switch Condition
    Specified Condition
    L4-4 (TACH) - L4-9 (GND)
    Power switch on (IG)
    Correct waveform appears as shown

    Text in Illustration 
    *1
    Rear view of wire harness connector
    (to Tire Pressure Warning ECU)
    Tool Setting 
    Item
    Contents
    Tool Setting
    0.5 V/DIV., 10 ms/DIV.

    HINT:
    1. The shape of waves like figure appears approximately 2 times every 3 minutes.
    2. Figure is one example, and the voltage with few changes might be detected between 49 mV and 4.95 V.



NG
Go to step 3
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)  

3.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - ANTENNA AND RECEIVER)
  1. Disconnect the L4 ECU connector.

  1. Disconnect the R2 tire pressure warning antenna and receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L4-4 (TACH) - R2-2 (RSSI)
    Always
    Below 1 Ω
    L4-4 (TACH) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ANTENNA AND RECEIVER