DTC U0100 Lost Communication with ECM / PCM |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0100 | No communication from the ECM continues. |
|

| 1.RECONFIRM DTC OUTPUT |
Reconfirm DTCs.
| Result | Proceed to |
| U1002 is not output from power management control ECU (Techstream display/Power Management2) | A |
| U1002 is output from power management control ECU (Techstream display/Power Management2) | B |
|
| ||||
| A | |
| 2.CHECK CAN BUS WIRE FOR DISCONNECTION (ECM MAIN WIRE/POWER MANAGEMENT BUS) |
Turn the power switch off.
![]() |
Disconnect the ECM connector.
| *1 | Front view of wire harness connector (to ECM) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A57-12 (CANP) - A57-4 (CANN) | Power switch off | 108 to 132 Ω |
|
| ||||
| OK | |
| 3.CHECK ECM POWER SOURCE CIRCUIT |
Check for the ECM power source circuit (Click here).
|
| ||||
| OK | ||
| ||