Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM

DTC    B2074    Driver Side Seat Belt Buckle Switch Circuit Malfunction

DTC    B2075    Passenger Side Seat Belt Buckle Switch Circuit Malfunction

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction is detected in the driver side buckle switch circuit or passenger side buckle switch circuit.

DTC No.
DTC Detection Condition
Trouble Area
B2074
Malfunction in front seat belt inner LH
  1. Wire harness
  2. Front seat inner belt LH assembly
  3. Center airbag sensor assembly
  4. Seat belt control ECU
B2075
Malfunction in front seat belt inner RH
  1. Wire harness
  2. Front seat inner belt RH assembly
  3. Occupant classification ECU
  4. Center airbag sensor assembly
  5. Seat belt control ECU

WIRING DIAGRAM


E182477E08


INSPECTION PROCEDURE

HINT:
This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection (Click here).

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    CAN communication system DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK DTC OUTPUT (AIR BAG SYSTEM)
  1. Check DTCs for the air bag system (Click here).

    OK:
    Airbag system DTC is not output.



NG
GO TO AIR BAG SYSTEM (Click here)
OK


3.CHECK DTC OUTPUT (OCCUPANT CLASSIFICATION SYSTEM)
  1. Check DTCs for the occupant classification system (Click here).

    OK:
    DTC B1771 is not output.



NG
GO TO OCCUPANT CLASSIFICATION SYSTEM (Click here)
OK


4.CHECK DTC OUTPUT (PRE-COLLISION SYSTEM)
  1. Using the Techstream, enter the following menus: Body Electrical / Pre-Collision / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    DTC B2074 or B2075 is not output.



NG
REPLACE SEAT BELT CONTROL ECU (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)