Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

LANE-KEEPING ASSIST SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the lane-keeping assist system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT AUXILIARY BATTERY VOLTAGE
    1. Measure the auxiliary battery voltage with the power switch off.

    2. Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN Communication System is functioning normally.
      Result 
      Result
      Proceed to
      CAN communication system DTC is not output
      A
      CAN communication system DTC is output
      B



    B.
    Go to CAN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK FOR DTC*
    1. Check for DTCs (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs (Click here).
      Result 
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccurs
      B



    B.
    Go to step 7
    A


    5.PROBLEM SYMPTOMS TABLE
    1. Problem symptoms table (Click here).


    2. Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. Data List / Active Test (Click here).


    NEXT


    7.REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END