DTC C1A40 ENG / EHV Device |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1A40 | While the power switch is on (IG), a hybrid control system or engine control system malfunction signal is detected for 1 second. |
|
| 1.CHECK DTC OUTPUT (HYBRID CONTROL SYSTEM) |
Check DTCs for the hybrid control system (Click here).
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT (ENGINE CONTROL SYSTEM) |
Check DTCs for engine control system (Click here).
|
| ||||
| OK | |
| 3.REPLACE POWER MANAGEMENT CONTROL ECU |
Replace the power management control ECU (Click here).
| NEXT | |
| 4.CHECK DTC OUTPUT (PRE-COLLISION SYSTEM) |
Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
Clear the DTCs (Click here).
Check for DTCs.
|
| ||||
| OK | ||
| ||