DTC C1A0C Object Recognition Camera Region Code Mismatch |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1A0C | While initial check is running, the power switch is on (IG) and the system is operating, country specification information in the driving support ECU and lane recognition camera sensor assembly do not match. |
|
| 1.REPLACE LANE RECOGNITION CAMERA SENSOR ASSEMBLY |
Replace the lane recognition camera sensor assembly (Click here).
Adjust the lane recognition camera sensor assembly (Click here).
| NEXT | |
| 2.CHECK DTC OUTPUT (PRE-COLLISION SYSTEM) |
Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
Clear the DTCs (Click here).
Turn the power switch off.
Turn the power switch on (IG).
Drive the vehicle.
Recheck for DTCs.
|
| ||||
| OK | ||
| ||