Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM

DTC    C1A20    Object Recognition ECU

for Preparation Click here


DESCRIPTION

for Lane keeping Assist System
When the driving support ECU receives information that there is a malfunction in the lane recognition camera sensor assembly, DTC C1A20 is stored.

DTC No.
DTC Detection Condition
Trouble Area
C1A20
When the vehicle speed is 50 km/h (30 mph) or more with lane keeping assist switch on, the driving support ECU receives information that there is a malfunction in the lane recognition camera sensor assembly for 1 second or more
  1. Lane recognition camera sensor assembly
  2. Driving support ECU

INSPECTION PROCEDURE

NOTICE:
When the lane recognition camera sensor assembly is replaced with a new one, adjust the lane recognition camera sensor assembly (Click here).

1.REPLACE LANE RECOGNITION CAMERA SENSOR ASSEMBLY
  1. Replace the lane recognition camera sensor assembly (Click here).

  1. Adjust the lane recognition camera sensor assembly (Click here).


NEXT


2.CHECK DTC OUTPUT (PRE-COLLISION SYSTEM)
  1. Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle at a speed of 50 km/h (30 mph) or more with lane keeping assist switch on.

  1. Recheck for DTCs.

    OK:
    DTC C1A20 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END