Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A45    Vehicle Speed Sensor

for Preparation Click here


DESCRIPTION

The driving support ECU receives vehicle speed signals from the brake booster with master cylinder (skid control ECU) via the CAN communication line to control the lane-keeping assist system. When the driving support ECU receives information that there is a malfunction in the vehicle speed sensor, DTC C1A45 is stored.

DTC No.
DTC Detection Condition
Trouble Area
C1A45
When vehicle speed is 50 km/h (31 mph) or more with lane-keeping assist switch on, malfunction in vehicle speed sensor is received from brake booster with master cylinder (skid control ECU)
  1. Vehicle speed sensor
  2. Brake booster with master cylinder (skid control ECU)
  3. CAN communication system
  4. Driving support ECU

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Check for DTCs.

    OK:
    CAN communication system DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK FOR DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle at a speed of 50 km/h (31 mph) or more, and operate lane keeping assist control.

  1. Check DTCs for electrical controlled brake system (Click here).

    OK:
    DTC C0200/31, C0205/32, C0210/33 or C0215/34 is not output.



NG
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM (Click here)
OK


3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER
  1. Replace the brake booster with master cylinder (skid control ECU) (Click here).


NEXT


4.CHECK DTC OUTPUT
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle at a speed of 50 km/h (31 mph) or more, and operate lane keeping assist control.

  1. Recheck for DTCs.

    OK:
    DTC C1A45 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END