Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A71    Power Steering Control Torque

for Preparation Click here


DESCRIPTION

When the lane departure warning function operates, the driving support ECU sends a signal to the power steering control ECU to operate the steering motor.

DTC No.
DTC Detection Condition
Trouble Area
C1A71
When lane keeping assist switch is on and vehicle speed is 50 km/h (31 mph) or more, driving support ECU receives torque abnormally signal from steering control system
  1. Power steering system
  2. CAN communication system
  3. Driving support ECU

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs (CAN communication system) (Click here).

    OK:
    CAN communication system DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK FOR DTC (POWER STEERING SYSTEM)
  1. Check for DTCs (power steering system) (Click here).

    OK:
    Power steering system DTC is not output.

    HINT:
    If DTC C1A71 is output even after troubleshooting the power steering system, replace the driving support ECU.



NG
GO TO POWER STEERING SYSTEM (Click here)
OK


3.REPLACE POWER STEERING CONTROL ECU
  1. Replace the power steering control ECU (Click here).


NEXT


4.CHECK FOR DTC
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle at a speed of 50 km/h (31 mph) or more, and operate lane keeping assist control.

  1. Recheck for DTCs.

    OK:
    DTC C1A71 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END