DTC C1A41 Brake Request Value Mismatch between ENG / EHV and Driving Support ECU |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1A41 | While power switch is on (IG), brake request signal from power management control ECU and driving support ECU are inconsistent for 1 second |
|
| 1.READ OUTPUT DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.READ OUTPUT DTC (HYBRID CONTROL SYSTEM) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 3.CHECK WHETHER DTC OUTPUT RECURS (DTC C1A41) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control main switch on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC C1A41 is output | B |
|
| ||||
| A | ||
| ||
| 4.REPLACE DRIVING SUPPORT ECU |
Replace the driving support ECU (Click here).
| NEXT | |
| 5.CHECK WHETHER DTC OUTPUT RECURS (DTC C1A41) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control main switch on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC C1A41 is output | B |
|
| ||||
| A | ||
| ||
| 6.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER |
Replace the brake booster with master cylinder (skid control ECU) (Click here).
| NEXT | |
| 7.CHECK WHETHER DTC OUTPUT RECURS (DTC C1A41) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control main switch on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC C1A41 is output | B |
|
| ||||
| A | ||
| ||