DTC C1A10 Front Radar Sensor |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1A10 | When the power switch is on (IG), the driving support ECU receives information that there is a malfunction in the millimeter wave radar sensor for approx. 1 second. |
|
| 1.REPLACE MILLIMETER WAVE RADAR SENSOR |
Replace the millimeter wave radar sensor (Click here).
| NEXT | |
| 2.ADJUST MILLIMETER WAVE RADAR SENSOR |
Adjust the millimeter wave radar sensor (Click here).
| NEXT | |
| 3.CHECK DTC OUTPUT (PRE-COLLISION SYSTEM) |
Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
Clear the DTCs (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||