DTC C1A11 Front Radar Sensor Incorrect Axial Gap |
DTC C1A14 Front Radar Sensor Beam Axis Not Adjusted |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1A11 | When the power switch is on (IG), misalignment of the millimeter wave radar sensor is detected for approx. 1 second. |
|
| C1A14 | When the power switch is on (IG), an unadjusted millimeter wave radar sensor beam axis is detected for approx. 1 second. |
|
| 1.ADJUST MILLIMETER WAVE RADAR SENSOR |
Check the millimeter wave radar sensor installation (Click here).
Adjust the millimeter wave radar sensor (Click here).
| NEXT | |
| 2.CHECK DTC OUTPUT (PRE-COLLISION SYSTEM) |
Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
Clear the DTCs (Click here).
Drive the vehicle.
Recheck for DTCs.
|
| ||||
| OK | ||
| ||