Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

DTC    B15F7    Certification ECU Vehicle Information Reading/Writing Process Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the navigation system vehicle customization screen.

HINT:
The certification ECU (smart key ECU assembly) controls the smart key system (for Entry Function) related items that are customizable via the multi-display screen.


DTC No.
DTC Detection Condition
Trouble Area
B15F7
Certification ECU (smart key ECU assembly) vehicle setting processing error.
  1. CAN communication system
  2. Smart key system (for Entry Function)
  3. Certification ECU (smart key ECU assembly)
  4. Radio and display receiver assembly

INSPECTION PROCEDURE

NOTICE:
After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).

    OK:
    CAN communication DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK SMART KEY SYSTEM (for Entry Function)
  1. Check if the smart key system (for Entry Function) is malfunctioning (Click here).

    HINT:
    Customization may not be possible depending on the malfunction in the smart key system (for Entry Function).

    OK:
    No malfunctions are present in the smart key system (for Entry Function).



NG
GO TO SMART KEY SYSTEM (for Entry Function) (Click here)
OK


3.CHECK CUSTOMIZE ITEMS
  1. Display the "Door Lock Settings" screen.

  1. Make a note of the customizable items for each certification ECU related system.

    HINT:
    These items shown as customizable via the navigation system vehicle customization screen can also be changed manually. In a following step, a manual procedure will be used.

    1. Check the customize parameters list for the smart key system (for Entry Function) related items that can be customized via the multi-display screen (Click here).

  1. Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the multi-display screen.

    OK:
    The items available for customization via the multi-display screen can be customized successfully using the manual procedure.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)