Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM

PRE-COLLISION SYSTEM > Pre-Collision Brake Cancel Switch Circuit

for Preparation Click here


DESCRIPTION

The driving support ECU receives pre-collision brake on/off signal from pre-collision system cancel switch.

WIRING DIAGRAM


E184698E04


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (PRE-COLLISION BRAKE CANCEL SWITCH)
  1. Use the Data List to check if the pre-collision brake cancel switch is functioning properly.

    Pre-Collision 2 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Pre-Collision Brake OFF Switch
    Pre-collision system cancel switch signal/ON or OFF
    ON: Pre-collision brake cancel switch on
    OFF: Pre-collision brake cancel switch off
    -

    OK:
    On screen, each item changes between ON and OFF according to above chart.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT PRE-COLLISION BRAKE CANCEL SWITCH ASSEMBLY


    E192823E01
  1. Remove the pre-collision brake cancel switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pressed
    Below 1 Ω
    Not pressed
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Pre-collision Brake Cancel Switch Assembly)

  1. Reinstall the pre-collision brake cancel switch assembly (Click here).



NG
REPLACE PRE-COLLISION BRAKE CANCEL SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (PRE-COLLISION BRAKE CANCEL SWITCH - DRIVING SUPPORT ECU)


    E192824E01
  1. Disconnect the pre-collision brake cancel switch assembly connector.

  1. Disconnect the driving support ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L108-1 - L60-5 (PBSW)
    Always
    Below 1 Ω
    L108-1 - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Pre-collision Brake Cancel Switch Assembly)
    *2
    Front view of wire harness connector
    (to Driving Support ECU)

  1. Reconnect the driving support ECU connector.

  1. Reconnect the pre-collision brake cancel switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (PRE-COLLISION BRAKE CANCEL SWITCH - DRIVING SUPPORT ECU)
OK


4.CHECK HARNESS AND CONNECTOR (PRE-COLLISION BRAKE CANCEL SWITCH ASSEMBLY - BODY GROUND)


    E193223E01
  1. Disconnect the pre-collision brake cancel switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L108-2 - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Pre-collision Brake Cancel Switch Assembly)

  1. Reconnect the pre-collision brake cancel switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (PRE-COLLISION BRAKE CANCEL SWITCH ASSEMBLY - BODY GROUND)
OK

REPLACE DRIVING SUPPORT ECU (Click here)