DTC C1210/36 Zero Point Calibration of Yaw Rate Sensor Undone |
DTC C1336/98 Zero Point Calibration of Acceleration Sensor Undone |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| C1210/36 | - | Yaw rate sensor zero point calibration is incomplete. |
|
| C1336/98 | - | Either of the following is detected:
|
|
| 1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR |
Perform zero point calibration of the yaw rate and acceleration sensor (Click here).
| NEXT | |
| 2.RECONFIRM DTC |
Turn the power switch off (lock).
Clear the DTCs (Click here).
Turn the power switch on (ready).
Drive the vehicle at a speed of 30 km/h (18 mph) or more, turn the steering wheel, and decelerate (depress the brake pedal) the vehicle.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTCs C1210/36 and/or C1336/98 are output. | A |
| DTCs C1210/36 and C1336/98 are not output. | B |
|
| ||||
| A | |
| 3.CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION |
Turn the power switch off (lock).
Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly (Click here).
|
| ||||
| OK | |
| 4.REPLACE AIRBAG SENSOR ASSEMBLY |
Replace the yaw rate and acceleration sensor (airbag sensor assembly) (Click here).
| NEXT | |
| 5.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the power switch on (ready).
Drive the vehicle at a speed of 30 km/h (18 mph) or more, turn the steering wheel, and decelerate (depress the brake pedal) the vehicle.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTCs C1210/36 and/or C1336/98 are output (for LHD). | A |
| DTCs C1210/36 and/or C1336/98 are output (for RHD). | B |
| DTCs C1210/36 and C1336/98 are not output. | C |
|
| ||||
|
| ||||
| A | ||
| ||