Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM3210E _58 Vehicle Interior _047539 SUPPLEMENTAL RESTRAINT SYSTEMS _0225220 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1625/22  Side Airbag Sensor LH Circuit Malfunction  


DESCRIPTION

The side collision sensor LH circuit (bus 1) consists of the airbag ECU assembly, door side airbag sensor LH, side airbag sensor assembly LH and rear airbag sensor LH.

The door side airbag sensor LH, side airbag sensor assembly LH and rear airbag sensor LH detect impacts to the vehicle and send signals to the airbag ECU assembly to determine if the airbags and pretensioners should be deployed.

DTC B1625/22 is stored when a malfunction is detected in the side airbag sensor assembly LH.

DTC No. Detection Item DTC Detection Condition Trouble Area Test Mode / Check Mode
B1625/22 Side Airbag Sensor LH Circuit Malfunction
·

Side airbag sensor assembly LH malfunction

·

Airbag ECU assembly malfunction


·

Side airbag sensor assembly LH

·

Airbag ECU assembly


Does not apply to test/check mode

CAUTION / NOTICE / HINT

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

1.CHECK SIDE AIRBAG SENSOR ASSEMBLY LH
a.
C313482C01
0.125,0.135 0.573,0.438 0.448,0.302 10 false *A 0.208,2.406 0.615,2.802 0.406,0.396 10 false *B 0.729,1.052 1.115,1.385 0.385,0.333 10 false *1 0.729,3.156 1.115,3.49 0.385,0.333 10 false *1 2.365,1.073 2.729,1.438 0.365,0.365 10 false *2 2.365,3.469 2.729,3.833 0.365,0.365 10 false *2 1.896,1.063 2.26,1.427 0.365,0.365 10 false A 1.74,1.063 2.104,1.427 0.365,0.365 10 false B 1.271,1.063 1.635,1.427 0.365,0.365 10 false C 1.115,1.063 1.479,1.427 0.365,0.365 10 false D 1.896,3.167 2.26,3.531 0.365,0.365 10 false A 1.74,3.167 2.104,3.531 0.365,0.365 10 false B 1.271,3.167 1.531,3.542 0.26,0.375 10 false C 1.115,3.167 1.375,3.542 0.26,0.375 10 false D
*A w/o Passenger Airbag ON/OFF Indicator
*B w/ Passenger Airbag ON/OFF Indicator
*1 Side Airbag Sensor Assembly RH
*2 Airbag ECU Assembly


Turn the power switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.

Interchange the side airbag sensor assembly LH with RH and connect the connectors.


d.

Connect the cable to the negative (-) auxiliary battery terminal.


e.

Clear the DTCs stored in memory.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR

Body Electrical > SRS Airbag > Clear DTCs
50002 188

f.

Turn the power switch off.


g.

Turn the power switch on (IG), and wait for at least 60 seconds.


h.

Check for DTCs.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR

Body Electrical > SRS Airbag > Trouble Codes
50001 188
HINT:

Codes other than DTCs B1620/21 and B1625/22 may be output at this time, but they are not related to this check.



Result:
Result Proceed to
DTC B1625/22 is output. A
DTC B1620/21 is output. B
DTCs B1620/21 and B1625/22 are not output. C


i.

Turn the power switch off.


j.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



k.

Return the side airbag sensor assembly LH and RH to their original positions and connect the connectors.



A

B

C