Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM3210E _58 Vehicle Interior _047539 SUPPLEMENTAL RESTRAINT SYSTEMS _0230372 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 89170A 1.INSTALL AIRBAG ECU ASSEMBLY

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
B394718

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B432352C01
0.656,2.646 0.656,3.052 true 0.594,3.063 0.906,3.219 0.313,0.156 10 false *a
*a Waterproof Sheet


Install the airbag ECU assembly with the 3 bolts.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)

NOTICE:
·

If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the airbag ECU assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

·

When the power switch is first turned on (IG) after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.




d.

Connect the connectors to the airbag ECU assembly as shown in the illustration.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



e.

Check that the waterproof sheet is properly set.


f.

Check that there is no looseness in the installed parts of the airbag ECU assembly.


Hide 58816C 2.INSTALL FRONT NO. 1 CONSOLE BOX INSERT

Hide 58817B 3.INSTALL FRONT NO. 2 CONSOLE BOX INSERT

Hide 55406B 4.INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55606 5.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62112 6.INSTALL COWL SIDE TRIM BOARD LH

Hide 67914 7.INSTALL FRONT DOOR SCUFF PLATE LH

Hide 8.INSTALL REAR CONSOLE BOX ASSEMBLY

Hide 9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 12. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

a.

When the airbag ECU assembly is replaced, perform zero point learning for the yaw rate and acceleration sensor.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>CALIBRATION

HINT:

The yaw rate and acceleration sensor is built into the airbag ECU assembly.