Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU
RM3210E _58 Vehicle Interior _047539 SUPPLEMENTAL RESTRAINT SYSTEMS _0230378 OCCUPANT CLASSIFICATION ECU A

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION ECU  INSTALLATION  


PROCEDURE

Hide 89952 1.INSTALL OCCUPANT DETECTION ECU

a.
B432363

Engage the claw to install the occupant detection ECU.

NOTICE:

If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.



b.

Connect the 2 connectors.

NOTICE:

When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is not pinched between other parts.



Hide 2.INSTALL FRONT SEAT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION


Hide 4. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK