Home › Vehicle Interior › HEATING / AIR CONDITIONING › ROOM TEMPERATURE SENSOR
RM3210E _58 Vehicle Interior _047534 HEATING / AIR CONDITIONING _0230758 ROOM TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  ROOM TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during room temperature sensor removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

PROCEDURE

Hide 58910C 1.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 73900 2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 55550 3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55406B 4.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 58848B 5.REMOVE SHIFT LEVER HOLE COVER

Hide 55433B 6.REMOVE NO. 2 LOWER INSTRUMENT PANEL FINISH PANEL

Hide 88625Q 7.REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR

a.
E337575C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws as shown in the illustration.


b.
E337577

Disconnect the connector and aspirator to remove the cooler (room temp. sensor) thermistor.