Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM3210E _58 Vehicle Interior _047509 METER / GAUGE / DISPLAY _0236932 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Meter Illumination is Always Dark  


DESCRIPTION

The combination meter assembly (meter circuit plate) receives signals from this circuit to adjust the illumination of the combination meter assembly (meter circuit plate). The combination meter assembly (meter circuit plate) sets the illumination level based on the user operation of the light control rheostat switch.

WIRING DIAGRAM

E143765E86
0.083,3.104 1.719,3.458 1.635,0.354 10 false Main Body ECU (Multiplex Network Body ECU) 2.927,3.167 3.021,3.354 0.094,0.188 10 false : 3.01,3.188 4.656,3.542 1.646,0.354 10 false CAN Communication Line 5.115,3.115 6.927,3.615 1.813,0.5 10 false Combination Meter Assembly (Meter Circuit Plate)

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.


HINT:
·

The meter illumination dims when the taillights are turned on.

·

Setting the meter illumination level to maximum brightness cancels the above dimming of the meter illumination.

·

Setting the meter illumination level to minimum brightness turns off the meter illumination.

·

The automatic light control sensor sensitivity can be customized.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication DTCs are not output. A
CAN communication DTCs are output. B



A

2.CHECK FOR DTC

B

2.CHECK FOR DTC
a.

Check if lighting system DTCs are output.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Result Proceed to
DTC B1244 is not output. A
DTC B1244 is output. B



A

3.REPLACE COMBINATION METER ASSEMBLY (METER CIRCUIT PLATE)

B

3.REPLACE COMBINATION METER ASSEMBLY (METER CIRCUIT PLATE)
a.

Replace the combination meter assembly (meter circuit plate) with a new or known good one.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>DISASSEMBLY

OK:

The operation of the combination meter assembly (meter circuit plate) returns to normal.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)