Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM(for RH Side)
RM3210E _53 Suspension _047519 FRONT SUSPENSION _0237147 FRONT LOWER SUSPENSION ARM(for RH Side) A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM(for RH Side)  INSTALLATION  


PROCEDURE

Hide 48068 1.TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

a.

Temporarily install the front lower No. 1 suspension arm sub-assembly RH to the front suspension crossmember sub-assembly with the 2 bolts and nut.


Hide 51201 2.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 48068 3.FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

a.
C345010C02
0.844,0.802 1.448,0.802 true 2.083,1.594 2.26,1.771 0.177,0.177 10 true *a 0.521,0.719 0.833,0.885 0.313,0.167 10 true SST 1.948,0.208 2.135,0.375 0.188,0.167 10 true A 2.781,1.479 2.969,1.646 0.188,0.167 10 true B
*a Torque Wrench Fulcrum Length
V113148

Turn


Using SST, fully tighten the bolt (A).

SST
09961-01270  

Torque:
Specified tightening torque : 240 N*m (2447 kgf*cm, 177 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 200 mm (7.87 in.)) + torque wrench (fulcrum length of 600 mm (1.97 ft.)):

180 N*m (1835 kgf*cm, 133 ft.*lbf)




b.

Fully tighten the bolt (B).

Torque:
125 N*m (1275 kgf*cm, 92 ft.*lbf)

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.



Hide 51442 4.INSTALL NO. 2 ENGINE UNDER COVER

Hide 51444C 5.INSTALL REAR MOTOR UNDER COVER LH

Hide 51443E 6.INSTALL REAR MOTOR UNDER COVER RH

Hide 51441 7.INSTALL NO. 1 ENGINE UNDER COVER

Hide 8.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Hide 9.PERFORM INITIALIZATION

Intelligent clearance sonar system
Simple intelligent parking assist system
(Click here)
Parking assist monitor system (Click here)
Automatic headlight beam level control system (Click here)