Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR
RM3210E _53 Suspension _047519 FRONT SUSPENSION _0237149 FRONT STABILIZER BAR A

FRONT SUSPENSION  FRONT STABILIZER BAR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front stabilizer bar removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Brake warning light / yellow (minor malfunction) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

Intelligent clearance sonar system

·

Simple intelligent parking assist system


(Click here)
Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system (Click here)
Initialize No. 1 headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)

PROCEDURE

Hide 51201 1.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 48810 2.REMOVE FRONT STABILIZER LINK ASSEMBLY LH

a.
C348712

Remove the nut and front stabilizer link assembly LH from the front shock absorber assembly.

NOTICE:

Do not damage the boot of the ball joint.


HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.



Hide 48820B 3.REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 4.REMOVE STEERING LINK ASSEMBLY

Hide 48829A 5.REMOVE FRONT NO. 1 STABILIZER BRACKET LH

a.
C345320

Remove the 2 bolts and front stabilizer bracket LH from the front suspension crossmember sub-assembly.


Hide 48824A 6.REMOVE FRONT NO. 1 STABILIZER BRACKET RH

HINT:

Perform the same procedure as for the LH side.


Hide 48811 7.REMOVE FRONT STABILIZER BAR

a.

Remove the front stabilizer bar with 2 front stabilizer bar bushings from the front suspension crossmember sub-assembly.


Hide 48815E 8.REMOVE FRONT STABILIZER BAR BUSHING LH

a.

Remove the front stabilizer bar bushing LH from the front stabilizer bar.


Hide 48815D 9.REMOVE FRONT STABILIZER BAR BUSHING RH

HINT:

Perform the same procedure as for the LH side.