Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER
RM3210E _56 Audio / Visual / Telematics _047511 NAVIGATION / MULTI INFO DISPLAY _0243248 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during navigation receiver assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for Navigation Receiver Type)>PRECAUTION

Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 55435A 3.REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

Hide 55405B 4.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 5.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

a.
E341720

Remove the 4 bolts.


b.
E341721C01
0,0 0,0 false
V113147

Remove in this Direction


Pull the navigation receiver assembly with bracket toward the rear of the vehicle and disengage the 2 guides.


c.

Disconnect each connector and remove the navigation receiver assembly with bracket.


Hide 86211 6.REMOVE NO. 1 RADIO BRACKET

a.
E341723C01
0.125,0.365 0.49,0.604 0.365,0.24 12 false *A 0.115,2.563 0.479,2.792 0.365,0.229 12 false *B
*A for Type A
*B for Type B


Remove the 3 screws and No. 1 radio bracket.


Hide 86212 7.REMOVE NO. 2 RADIO BRACKET

a.
E341724C01
0.083,0.198 0.438,0.458 0.354,0.26 12 false *A 0.125,2.385 0.479,2.646 0.354,0.26 12 false *B
*A for Type A
*B for Type B


Remove the 3 screws and No. 2 radio bracket.


Hide 86120L 8.REMOVE NAVIGATION RECEIVER ASSEMBLY