Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING
RM3210E _59 Vehicle Exterior _047542 EXTERIOR PANELS / TRIM _0243314 FRONT DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front door belt moulding removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
·

Front door glass sub-assembly

·

Front door glass run


Initialize Power Window Control System
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Window open warning function


(Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 69284F 3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 74220 4.REMOVE FRONT ARMREST ASSEMBLY

Hide 5.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Hide 81230 7.REMOVE COURTESY LIGHT ASSEMBLY

Hide 67602 8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 9.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL

Hide 67856B 10.REMOVE FRONT DOOR PANEL PROTECTOR

Hide 87940 11.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

Hide 67836C 12.REMOVE FRONT DOOR NO. 3 SERVICE HOLE COVER

Hide 67832 13.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68102 14.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 75720 15.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY

a.
B436015C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front door belt moulding assembly.


b.
B436016C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 6 claws as shown in the illustration to remove the front door belt moulding assembly.