Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL(for RHD)
RM3210E _54 Brake _047522 PARKING BRAKE _0243349 PARKING BRAKE PEDAL(for RHD) A

PARKING BRAKE  PARKING BRAKE PEDAL(for RHD)  REMOVAL  


PROCEDURE

Hide 46441 1.LOOSEN NO. 1 WIRE ADJUSTING NUT

a.
C345628

Loosen the No. 1 wire adjusting nut.

NOTICE:

If the No. 1 wire adjusting nut has been removed from the No. 1 parking brake cable assembly, replace the No. 1 wire adjusting nut with a new one.



Hide 55606 2.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 58910C 3.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 55406B 4.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 58817B 5.REMOVE FRONT NO. 2 CONSOLE BOX INSERT

Hide 55362C 6.REMOVE PARKING BRAKE MOUNTING BRACKET

Hide 87211A 7.REMOVE NO. 2 AIR DUCT

Hide 46410 8.SEPARATE NO. 1 PARKING BRAKE CABLE ASSEMBLY

a.

Turn back the front floor carpet assembly.


b.
C345633

Remove the bolt and separate the No. 1 parking brake cable assembly.


Hide 46250 9.SEPARATE PARKING BRAKE PEDAL ASSEMBLY

a.
C345634

Disengage the 2 clamps.


b.

Disconnect the parking brake switch connector.


c.
C345635C02
0,0 0,0 false
V100155

Bracket


Remove the bolt and 2 nuts, and separate the parking brake pedal assembly from the vehicle body.

NOTICE:

Be careful not to deform the bracket of the instrument panel reinforcement assembly shown in the illustration.



Hide 46250 10.REMOVE PARKING BRAKE PEDAL ASSEMBLY

a.
C345636

Pull up the parking brake pedal assembly claw.

NOTICE:

Do not damage the No. 1 parking brake cable assembly.



b.
C345637

Remove the No. 1 wire adjusting nut from the No. 1 parking brake cable assembly.

NOTICE:

If the No. 1 wire adjusting nut has been removed from the No. 1 parking brake cable assembly, replace the No. 1 wire adjusting nut with a new one.



c.
C345638

Remove the clip from the No. 1 parking brake cable assembly.


d.

Remove the parking brake pedal assembly from the No. 1 parking brake cable assembly.