The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEELS
51441
2.REMOVE NO. 1 ENGINE UNDER COVER
51444C
3.REMOVE REAR MOTOR UNDER COVER LH
51443E
4.REMOVE REAR MOTOR UNDER COVER RH
5.DRAIN HYBRID TRANSAXLE FLUID
43502H
6.REMOVE FRONT AXLE SHAFT NUT
Using SST and a hammer, release the staked part of the front axle shaft nut.
Loosen the staked part of the front axle shaft nut completely, otherwise the threads of the drive shaft may be damaged.
While applying the brakes, remove the front axle shaft nut.
89543
7.SEPARATE FRONT SPEED SENSOR
45047
8.SEPARATE TIE ROD END SUB-ASSEMBLY
48810
9.SEPARATE FRONT STABILIZER LINK ASSEMBLY
48069
10.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
11.SEPARATE FRONT DRIVE SHAFT ASSEMBLY
43420
12.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Using SST, remove the front drive shaft assembly LH.
Do not damage the front drive shaft oil seal LH.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly LH.
43410
13.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Perform the same procedure as for the LH side.
43420G
14.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING
Using a screwdriver, remove the front drive shaft hole snap ring.