The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal support assembly removal/installation are shown below.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
1.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
89510D
2.REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY
84340
3.REMOVE STOP LIGHT SWITCH ASSEMBLY
84345
4.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
47101A
5.REMOVE BRAKE PEDAL RETURN SPRING
Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.
47264A
6.REMOVE PUSH ROD PIN
Remove the clip and push rod pin to separate the brake pedal support assembly from the brake master cylinder push rod clevis.
47110
7.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
Disengage the clamp to separate the wire harness from the brake pedal support assembly.
Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.
|
Nut |
|
Clip |
Remove the 2 clips.
Remove the 4 nuts and brake pedal support assembly.
Remove the nut from the brake pedal support assembly.
47121
8.REMOVE BRAKE PEDAL PAD
Remove the brake pedal pad from the brake pedal support assembly.