The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during stop light switch assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
73900
1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
58910C
2.REMOVE REAR CONSOLE BOX ASSEMBLY (for RHD)
55406B
3.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for RHD)
58816C
4.REMOVE FRONT NO. 1 CONSOLE BOX INSERT (for RHD)
55362C
5.REMOVE PARKING BRAKE MOUNTING BRACKET (for RHD)
87211A
6.REMOVE NO. 2 AIR DUCT (for RHD)
84340
7.REMOVE STOP LIGHT SWITCH ASSEMBLY
Disconnect the connector.
|
Remove in this Direction |
Turn the stop light switch assembly counterclockwise and remove it.