Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door)
RM3210E _59 Vehicle Exterior _047515 WINDOW / GLASS _0244713 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 85720E 2.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.


a.

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 3.INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

Hide 68104 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 68124B 5.INSTALL REAR DOOR QUARTER WINDOW GLASS

Hide 67408E 6.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 67872 7.CONNECT REAR DOOR WEATHERSTRIP

Hide 68152C 8.INSTALL REAR DOOR GLASS RUN

Hide 67844A 9.INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER

Hide 67858B 10.INSTALL REAR DOOR PANEL PROTECTOR

Hide 67842E 11.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 12.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP WITH REAR DOOR NO. 2 VENT SEAL

Hide 67604 13.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 14.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 74260 15.INSTALL REAR ARMREST ASSEMBLY

Hide 69284G 16.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 17.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 18.INITIALIZE POWER WINDOW CONTROL SYSTEM