Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM3210E _53 Suspension _047536 REAR SUSPENSION _0244743 REAR STABILIZER BAR A

REAR SUSPENSION  REAR STABILIZER BAR  INSTALLATION  


PROCEDURE

Hide 48818 1.INSTALL REAR STABILIZER BUSHING

a.

Install the 2 rear stabilizer bushings to the rear stabilizer bar.

NOTICE:

Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.



Hide 48832A 2.INSTALL REAR NO. 1 STABILIZER BAR BRACKET

a.
C349813C02
1.406,1.844 1.24,1.844 1.24,1.844 1.24,1.521 false 1.438,1.771 1.75,1.927 0.313,0.156 10 false *a
*a Arrow Mark
V100136

Front of the Vehicle


Install the 2 rear No. 1 stabilizer bar brackets to the 2 rear stabilizer bushings.

NOTICE:

Be sure to install the rear No. 1 stabilizer bar brackets so that each arrow mark faces the front of the vehicle.



Hide 48812 3.INSTALL REAR STABILIZER BAR

a.
C345106C02
0.583,1.385 0.583,1.073 true 0.5,1.406 0.771,1.635 0.271,0.229 10 true *a 0.969,0.594 1.135,0.76 0.167,0.167 10 true A 0.99,1.531 1.156,1.698 0.167,0.167 10 true B 2.396,1.521 2.563,1.688 0.167,0.167 10 true B 2.385,0.594 2.552,0.76 0.167,0.167 10 true A
*a Identification Mark


Install the rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings to the rear suspension member sub-assembly with the 4 bolts.

Torque:
78 N*m (795 kgf*cm, 58 ft.*lbf)

NOTICE:
·

Ensure that the identification mark faces the right side of the vehicle.

·

Temporarily tighten bolt (A) and then fully tighten the 2 bolts in the order of (B) and (A).




Hide 48840A 5.INSTALL REAR STABILIZER LINK ASSEMBLY LH

a.
C345067N01
1.885,1.396 2.073,1.604 0.188,0.208 10 true A 1.26,4.271 1.448,4.479 0.188,0.208 10 true B

Install the rear stabilizer link assembly LH with the nut (A).

Torque:
75 N*m (765 kgf*cm, 55 ft.*lbf)

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.



b.

Install the rear stabilizer link assembly LH with the bolt and nut (B).

Torque:
75 N*m (765 kgf*cm, 55 ft.*lbf)

NOTICE:

Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.



Hide 48830D 6.INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 57628C 7.INSTALL REAR FLOOR SIDE MEMBER COVER LH

Hide 58390 8.INSTALL NO. 1 FLOOR UNDER COVER ASSEMBLY