The front side ultrasonic sensor LH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front side ultrasonic sensor LH. If the front side ultrasonic sensor LH has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE0 | Front Left Side Sensor | A malfunction of the front side ultrasonic sensor LH. | ·
Front side ultrasonic sensor LH ·
Clearance warning ECU assembly |
If DTCs are output after repairs, turn the power switch on (IG) and the TOYOTA parking assist-sensor system on. Then clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC C1AE0 is output | A |
| DTC C1AE0 and C1AEE are output | B |
| No DTCs are output | C |
A
B
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>C1AEE
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Replace the front side ultrasonic sensor LH with a new or known good one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>REMOVAL
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a new or known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1AE0 is output | A |
| No DTCs are output | B |
A
B