The front center ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultrasonic sensor RH. If the front center ultrasonic sensor RH has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE3 | Front Right Center Sensor | A malfunction of the front center ultrasonic sensor RH. | ·
Front center ultrasonic sensor RH ·
Clearance warning ECU assembly |
If DTCs are output after repairs, turn the power switch on (IG) and the TOYOTA parking assist-sensor system on. Then clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC C1AE3 is output | A |
| DTC C1AE3 and C1AEC are output | B |
| No DTCs are output | C |
A
B
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>C1AEC
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Replace the front center ultrasonic sensor RH with a new or known good one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>REMOVAL
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a new or known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1AE3 is output | A |
| No DTCs are output | B |
A
B