This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.
If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor system on, the blind spot monitor sensor may store this DTC by mistake.
When mud, snow, ice, a sticker, etc. is covering the sensor or its surrounding area on the rear bumper, the blind spot monitor sensor may store this DTC by mistake.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AC2 | Slave Module Horizontal Axis Misalignment | When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated | Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Check the condition of the rear bumper around the blind spot monitor sensors.
When mud, snow, ice, a sticker, etc. is covering the sensor or its surrounding area on the rear bumper, the blind spot monitor sensor may store this DTC by mistake.
| Result | Proceed to |
|---|---|
| A sticker, mud, snow, ice, etc. is covering the sensor or surrounding area on the rear bumper. | A |
| There are scratches or dents on the rear bumper around the sensors. | B |
| No abnormalities. |
A
B
Clean the rear bumper.
Perform Blind Spot Monitor Beam Axis Confirmation using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
| Tester Display |
|---|
| BSM Slave Beam Axis Display |
| Tester Display |
|---|
| BSM Slave Beam Axis Adjustment |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SENSOR>REMOVAL
Before replacing the blind spot monitor sensor RH, visually check for damage to the stud bolts or area surrounding the blind spot monitor sensor RH.
If there is any damage to the stud bolts or area surrounding the blind spot monitor sensor RH, perform Blind Spot Monitor Sensor Installation Condition Inspection and adjust according to the result.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
Check the installation condition of the blind spot monitor sensor RH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
Take the appropriate action in accordance with the result.
| Proceed to |
|---|
| NEXT |
NEXT
Install the rear bumper.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER>INSTALLATION
Perform Blind Spot Monitor Beam Axis Confirmation using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
| Tester Display |
|---|
| BSM Slave Beam Axis Display |
| Tester Display |
|---|
| BSM Slave Beam Axis Adjustment |
| Proceed to |
|---|
| OK |
| NG |
OK
NG