739F0
1.INSTALL FRONT SEAT CUSHION AIRBAG ASSEMBLY RH
Pass the airbag wire harness through the hole.
Install the front seat cushion airbag assembly RH with 3 new nuts.
The nuts must not be reused.
Make sure that the front seat adjuster assembly RH is not deformed. If it is, replace it with a new one.
Engage the claw and 2 clamps.
Engage the claw first.
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
3.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
71861
4.INSTALL FRONT SEAT INNER CUSHION SHIELD RH
71811D
5.INSTALL FRONT SEAT CUSHION SHIELD RH
72525A
6.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
72551
7.INSTALL NO. 1 RECLINING HINGE COVER
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
71073S
8.CONNECT SEPARATE TYPE FRONT SEATBACK COVER
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
9.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION
10. PERFORM DIAGNOSTIC SYSTEM CHECK