DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Aug 2008
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008
| DIAGNOSIS |


- HINT:
- The DTCs can be read by connecting SST (09843-18040) between the TC and CG terminals of the DLC3 and observing the blinking pattern of the ABS and slip indicator lights, or by using the intelligent tester (Click here).
- This system has a sensor signal check function (Click here).
- The DTCs can be read by connecting SST (09843-18040) between the TC and CG terminals of the DLC3 and observing the blinking pattern of the ABS and slip indicator lights, or by using the intelligent tester (Click here).
| CHECK WARNING LIGHT AND INDICATOR LIGHT |
Release the parking brake lever.
- NOTICE:
- Before releasing the parking brake lever, set chocks to hold the vehicle for safety.
- HINT:
- When the parking brake is applied or the brake fluid level is low, the brake warning light comes on.
When the ignition switch is turned to ON, check that the ABS and brake warning lights and the slip, VSC OFF, TRC OFF, downhill assist control and AUTO LSD indicator lights come on and go off in about 3 seconds.


- HINT:
- If the warning lights do not illuminate, check for combination meter and CAN communication system DTCs, since the skid control ECU and combination meter are connected by the CAN communication line.
- If the warning light remains on, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are in the sections listed in the table below.
Section Title
See Procedure
ABS Warning Light Remains ON
Click here
VSC OFF Indicator Light Remains ON
Click here
Brake Warning Light Remains ON
Click here
Slip Indicator Light Remains ON
Click here
Downhill Assist Control Indicator Light Remains ON
Click here
AUTO LSD Indicator Light Remains ON
Click here
TRC OFF Indicator Light Remains ON
Click here