Circuit diagnosis · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Jan 2007 – Jul 2007from Aug 2007
DESCRIPTION
The glow plug is mounted inside the engine combustion chamber. To ensure efficient engine starting with a cold engine, the ECM calculates a time interval of the current that needs to flow through the glow plug depending on the starting engine coolant temperature when the ignition switch is turned on (IG). The ECM then turns on the glow plug relay and permits the current to flow through the glow plug based on the ECM's calculated time. The glow plug relay is then heated, and enhances fuel combustion with a cold engine. This DTC will be set if the glow plug or the circuit is open.
HINT:
These troubleshooting procedures are for: 1) difficult starting engine in cold weather, and 2) difficulty driving / vehicle malfunctions in cold weather immediately after engine is started.
After the engine is started, the ECM performs an "after-glow" for a certain period of time. In proportion to the actual engine coolant temperature, the time period varies. The after-glow reduces diesel engine knocking, white smoke emissions and engine noises when the engine is cold.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
1. CHECK TERMINAL VOLTAGE (GREL TERMINAL)
Remove the glow plug relay.
Turn the ignition switch on (IG) and turn the tester ON.
Measure the voltage of the wire harness side connector.