2005-2008 RAV4 · Service Manual BRAKE

C1337 Different Diameter Tire Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2008

DESCRIPTION

The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors.
These signals are used for recognizing that all 4 wheels are operating properly.
Therefore, all wheel signals must be equal.
DTC Code
DTC Detection Condition
Trouble Area
C1337
The following occurs in 3 consecutive trips:
At a vehicle speed of 20 km/h (12 mph) or more, there is a 20% difference or more in the average speed between the front wheels and rear wheels for 20 seconds or more.
  1. Tire and wheel size
  2. Tire deformation
  3. Speed sensor rotor
  4. Speed sensor
  5. Speed sensor circuit
  6. Brake actuator assembly (Skid control ECU)

WIRING DIAGRAM

C194399E02

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

HINT:
When C1401 to C1408 and/or C1413 to C1416 are output with C1337, inspect and repair the trouble areas indicated by C1401 to C1408 and/or C1413 to C1416 first (Click here).


1. CHECK TIRES
  1. Check the size and condition of all 4 wheels (Click here).

    HINT:
    The DTC is output when tire deformation or a difference in tire size is detected.

    OK:
    The diameter of all 4 tires and air pressure are the same.



NG
REPLACE TIRES SO THAT ALL FOUR TIRES ARE SAME SIZE
OK


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.

  1. Check if the same DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC (C1337) is output.
    A
    DTC (C1337) is not output.
    B



B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← C1290/66 Steering Angle Sensor Zero Point Malfunction (Aug 2007 – Jul 2008)C1337/37 Different Diameter Tire Malfunction (Nov 2005 – Dec 2006) →