C1337/37 Different Diameter Tire Malfunction
Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008
DESCRIPTION
The skid control ECU measures the speed of each wheel by receiving signals from the speed sensor. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must be equal.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1337/37 |
With vehicle speed at 20 km/h (12 mph), condition that difference in average speed between front wheels and rear wheels is 20% or more continues for 20 seconds, and occurs consecutively 3 times each time the vehicle is driven |
Tire size |
INSPECTION PROCEDURE
| 1. CHECK TIRE SIZE |
Check the diameter of all 4 tires.
- OK:
- Diameter of all 4 tires are equal.
|
|
||||
| OK | |
| 2. CHECK SPEED SENSOR ROTOR |
Remove the drive shaft, and check around the speed sensor rotor.
- OK:
- No scratches or foreign matter on the sensor tip.
|
|
||||
| OK | |
| 3. CHECK SPEED SENSOR |
Check the speed sensor circuit (Click here or Click here).
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (SKID CONTROL ECU - EACH SPEED SENSOR) |
Check the speed sensor circuit (Click here or Click here).
|
|
||||
| OK | |
| 5. RECONFIRM DTC |
Clear the DTCs (Click here).
Drive the vehicle at more than 20 km/h (12 mph) for more than 60 seconds.
Check if the same DTCs are detected.
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
