2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Nov 2005


DTC CHECK (USING INTELLIGENT TESTER)

  1. B127990E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Read the DTCs following the prompts on the tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CHECK DTC (USING SST CHECK WIRE)

  1. H100769E17
    Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
    SST
    09843-18040  

  2. F101014
    Turn the ignition switch on (IG).

  3. F101046E01
    Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration for examples of a normal system code and DTCs 13 and 33.

    HINT:
    1. If the tire pressure warning light does not blink to indicate any DTCs or the normal system code, inspect the tire pressure warning light circuit or 13 (TC) and 4 (CG) terminal circuits.
      Trouble Area
      See procedure
      Tire pressure warning light circuit
      Click here
      TC and CG terminal circuit
      Click here
    1. If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.

  4. Refer to the Diagnostic Trouble Code Chart for DTC information (Click here).

  5. After completing the check, turn the ignition switch off and remove SST from the DLC3.


CLEAR THE DTC (USING INTELLIGENT TESTER)

HINT:
After repairing the malfunctions, clear the DTCs.

  1. B127990E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Erase the DTCs following the prompts on the tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

← DIAGNOSIS SYSTEM (from Nov 2005)DATA LIST / ACTIVE TEST (from Nov 2005) →