2005-2008 RAV4 · Service Manual HEATER & AIR CONDITIONING SYSTEM

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

HINT:
  1. Use these procedures to troubleshoot the air conditioning system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
      NEXT

      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.
      NEXT

      4.CHECK CAN COMMUNICATION SYSTEM*
      1. Use the intelligent tester to check if the CAN communication system is functioning.

        Result:
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B (Click here)


      B.
      A

      5.CHECK DTC
      1. Check for DTCs and write down any DTCs that are output.

      2. Clear the DTCs.

      3. Recheck for DTCs. Based on the DTCs output above, try to cause output of the A/C system DTC by simulating the operation indicated by the DTC.

        Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      A

      6.REFER TO PROBLEM SYMPTOMS TABLE

        Result:
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      A

      7.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here).

      2. Terminals of ECU (Click here).

      NEXT

      8.ADJUST, REPAIR OR REPLACE
        NEXT

        9.CONFIRMATION TEST
          NEXT

          ← HOW TO PROCEED WITH TROUBLESHOOTING (Nov 2005 – Dec 2006)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2007) →