HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use these procedures to troubleshoot the air conditioning system.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK |
| NEXT |
|
 |
|
|
| 3.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
| 4.CHECK CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning.
- Result:
Result
|
Proceed to
|
CAN DTC is not output
|
A
|
CAN DTC is output
|
B (Click here)
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Check for DTCs and write down any DTCs that are output.
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to cause output of the A/C system DTC by simulating the operation indicated by the DTC.
- Result:
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.REFER TO PROBLEM SYMPTOMS TABLE |
- Result:
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here).
Terminals of ECU (Click here).
| NEXT |
|
 |
|
|
| 8.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|