2005-2008 RAV4 · Service Manual BRAKE

C1210/36 Zero Point Calibration of Yaw Rate Sensor Undone

Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006

Also covers:

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008

DESCRIPTION

The ABS and TRACTION actuator (Skid control ECU) receives signals from the yaw rate and deceleration sensor via the CAN communication system. The yaw rate sensor has a built-in deceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2). If there are problems in the bus lines between the yaw rate and deceleration sensor and the CAN communication system, DTCs U0123/62 (yaw rate sensor communication trouble) and U0124/95 (deceleration sensor communication trouble) are output. The DTCs are also output when the calibration has not been completed.
DTC No.
DTC Detection Condition
Trouble Area
C1210/36
Zero point calibration of yaw rate sensor not completed
  1. ABS and TRACTION actuator (skid control ECU)
  2. Zero point calibration incomplete
  3. Yaw rate sensor
C1336/39
When either condition below is met:
  1. Vehicle driven without completion of zero point calibration
  2. After zero point has been obtained, zero point voltage of sensor not between 2.38 V and 2.62 V
  1. ABS and TRACTION actuator (skid control ECU)
  2. Zero point calibration incomplete
  3. Yaw rate sensor

WIRING DIAGRAM

C126308E01
C126309E01

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).

HINT:
When U0123/62, U0124/95 or U0126/63 is output together with C1210/36 or C1336/39, inspect and repair trouble areas indicated by U0123/62, U0124/95 or U0126/63 first.


1. CHECK YAW RATE SENSOR INSTALLATION
  1. Check that the yaw rate sensor has been installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not tilted.



NG
INSTALL YAW RATE SENSOR CORRECTLY
OK


2. PERFORM ZERO POINT CALIBRATION OF YAW RATE SENSOR
  1. Perform zero point calibration of the yaw rate and deceleration sensor (Click here).


NEXT


3. RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Start the engine.

  1. Drive the vehicle and turn the steering wheel to the right and left at a speed of 45 km/h (28 mph) or more.

  1. Check if the same DTC(s) is recorded (Click here).

    Result 
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B

    HINT:
    1. The DTC(s) is set if the zero point calibration has not been completed successfully.
    2. End the procedure when the same DTC(s) is not set after completion of the zero point calibration.



B
END
A

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← C1210 Zero Point Calibration of Yaw Rate Sensor Undone (+ C1336) (from Aug 2008)C1210/36 Zero Point Calibration of Yaw Rate Sensor Undone (+ C1336/39) (Jan 2007 – Jul 2007) →