2005-2008 RAV4 · Service Manual BRAKE

Slip Indicator Light does not Come ON

Circuit diagnosis · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

DESCRIPTION

Refer to the description of "Slip Indicator Light Remains ON" (Click here).

WIRING DIAGRAM

Refer to the SLIP indicator light circuit (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)
  1. Using the intelligent tester's Active Test, generate a control command, and then check that the Slip indicator light operates.

    Skid control ECU 
    Item (Display)
    Test Details
    Diagnostic Note
    Slip Indicator Lamp
    Turn slip indicator light ON / OFF
    Observe combination meter

    OK:
    The Slip indicator light turns ON and OFF.



NG
Go to step 3
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY

3. CHECK COMBINATION METER
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← Slip Indicator Light Remains ON (from Aug 2008)Slip Indicator Light does not Come ON (Jan 2007 – Jul 2007) →