2005-2008 RAV4 · Service Manual BRAKE

Slip Indicator Light Remains ON

Circuit diagnosis · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

DESCRIPTION

The slip indicator blinks during VSC and/or TRC operation.
When the VSC/TRC system fails, the slip indicator comes on to warn the driver.

WIRING DIAGRAM

C194142E02

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform the zero point calibration (Click here).


1. PREPARE FOR INSPECTION
  1. Check that the following condition is satisfied.

    1. The vehicle is not in inspection mode.

      HINT:
      Confirm if the vehicle is in the inspection mode or not by using the intelligent tester Data List.


NEXT


2. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A


3. CHECK SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


4. INSPECT COMBINATION METER ASSEMBLY
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← Slip Indicator Light Remains ON (Aug 2007 – Jul 2008)Slip Indicator Light does not Come ON (Nov 2005 – Dec 2006) →