2005-2008 RAV4 · Service Manual BRAKE

Slip Indicator Light does not Come ON

Circuit diagnosis · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

DESCRIPTION

Refer to the description of "Slip Indicator Light Remains ON" (Click here).

WIRING DIAGRAM

Refer to the slip indicator light circuit (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform the zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select the Active Test mode on the intelligent tester (Click here).

    ABS/VSC/TRC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Slip Indicator Light
    Slip indicator light
    Indicator light ON / OFF
    Observe the combination meter.

    OK:
    The slip indicator light turns ON and OFF.



NG
Go to step 3
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

3. INSPECT COMBINATION METER ASSEMBLY
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← Slip Indicator Light does not Come ON (Aug 2007 – Jul 2008)Downhill Assist Control Indicator Light Remains ON (Nov 2005 – Dec 2006) →