2005-2008 RAV4 · Service Manual BRAKE

C1232 Acceleration Sensor Stuck Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2008

Also covers:

DESCRIPTION

The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in deceleration sensor and detects the vehicle condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and deceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are stored.
DTC Code
DTC Detection Condition
Trouble Area
C1232
At a vehicle speed of 10 km/h (6 mph) or more, acceleration sensor output value does not change for 30 seconds or more.
  1. Sensor installation
  2. Yaw rate and deceleration sensor
C1243
While the vehicle speed changes from 30 km/h (19 mph) to 0 km/h (0 mph), the condition that the value of acceleration sensor does not change by 0.0294 G or more occurs 16 times or more.
  1. Sensor installation
  2. Yaw rate and deceleration sensor
C1245
At a vehicle speed of 30 km/h (19 mph) or more, the difference between the forward and backward G calculated from the acceleration sensor value and that calculated from the vehicle speed sensor exceeds 0.35 G for 60 seconds or more.
  1. Sensor installation
  2. Yaw rate and deceleration sensor

WIRING DIAGRAM

C190271E06

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate sensor assembly, perform zero point calibration (Click here).

HINT:
When U0123, U0124 and/or U0126 is output together with C1232, C1243, and/or C1245, inspect and repair the trouble areas indicated by U0123, U0124 and/or U0126 first (Click here).


1. CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION
  1. Check that the yaw rate and deceleration sensor has been installed properly (Click here).

    OK:
    The sensor should be tightened to the specified torque.
    The sensor should not be installed in a tilted position.

    NOTICE:
    Check the yaw rate and deceleration sensor signal after replacement (Click here).

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
INSTALL YAW RATE AND DECELERATION SENSOR CORRECTLY (Click here)
OK

REPLACE YAW RATE SENSOR ASSEMBLY (Click here)


← C1231/31 Steering Angle Sensor Circuit Malfunction (Aug 2007 – Jul 2008)C1232/32 Stuck in Deceleration Sensor (+ 7 more codes) (Nov 2005 – Dec 2006) →