2005-2008 RAV4 · Service Manual STEERING

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008

HINT:
Perform troubleshooting in accordance with the following flowchart.
*: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.PROBLEM SYMPTOM CONFIRMATION
      NEXT

      4.CHECK CAN COMMUNICATION SYSTEM*
      1. Check for DTC (Click here).

        Result 
        Result
        Proceed to
        CAN system DTC is not output
        A
        CAN system DTC is output
        B

        HINT:
        1. When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
        2. When communication to the power steering ECU is not established through the intelligent tester, inspect terminals SIL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.


      B.
      A

      5.CHECK DTC*
      1. Check for DTC (Click here).

        Result 
        Result
        Proceed to
        DTC is output
        A
        DTC is not output
        B


      A.
      B

      6.PROBLEM SYMPTOMS TABLE
        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B

      B.
      A

      7.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Terminals of ECU (Click here).

      2. Data List / Active Test (Click here).

      NEXT

      8.REPAIR OR REPLACE
        NEXT

        9.CONFIRMATION TEST
          NEXT

          ← HOW TO PROCEED WITH TROUBLESHOOTING (Nov 2005 – Jul 2008)PROBLEM SYMPTOMS TABLE (Nov 2005 – Dec 2006) →