HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Nov 2005 – Jul 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
- HINT:
- Perform troubleshooting in accordance with the following flowchart.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.PROBLEM SYMPTOM CONFIRMATION |
| |||||
| 4.CHECK CAN COMMUNICATION SYSTEM* |
Check for DTC (Click here).
Result Result
Proceed to
CAN system DTC is not output
A
CAN system DTC is output
B
- HINT:
- When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
- When communication to the power steering ECU is not established through the intelligent tester, inspect terminals SIL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.
- When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
|
|||||
| |||||
| 5.CHECK DTC* |
Check for DTC (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
| Result |
Proceed to |
| Fault is not listed in problem symptoms table |
A |
| Fault is listed in problem symptoms table |
B |
|
|||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here).
Data List / Active Test (Click here).
| |||||
| 8.REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||