2005-2008 RAV4 · Service Manual STEERING

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

HINT:
Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptoms by checking the suspected areas in the order they are listed. Replace parts as necessary.

Steering lock system 
Symptom
Suspected Area
See page
Steering wheel cannot unlock (engine cannot start).
1. Entry and start system (for 1AZ-FE)
Click here
2. Entry and start system (for 2AZ-FE)
Click here
3. Entry and start system (for 2AD-FHV)
Click here
4. Entry and start system (for 2AD-FTV)
Click here
5. Instrument panel junction block (Main body ECU)
-
6. Certification ECU
-
7. Steering lock motor drive power circuit
Click here
8. Power source circuit
Click here
9. Steering lock actuator (Steering lock ECU)
Click here
10. Unlock position sensor signal circuit
Click here
Steering wheel cannot unlock (after connecting intelligent tester to DLC3, starting engine, Data List certification ECUs item Lock/Unlock Receive data is read, and steering lock command reception records display is NO).
1. Entry and start system (for 1AD-FE)
Click here
2. Entry and start system (for 2AZ-FE)
Click here
3. Entry and start system (for 2AD-FHV)
Click here
4. Entry and start system (for 2AD-FTV)
Click here
5. ID code box
-
6. Instrument panel junction block (Main body ECU)
-
7. Certification ECU
-
8. LIN communication line
Click here
Steering wheel cannot lock.
1. Entry and start system (for 1AZ-FE)
Click here
2. Entry and start system (for 2AZ-FE)
Click here
3. Entry and start system (for 2AD-FHV)
Click here
4. Entry and start system (for 2AD-FTV)
Click here
5. Instrument panel junction block (Main body ECU)
-
6. Certification ECU
-
7. Steering lock motor drive power circuit
Click here
8. Power source circuit
Click here
9. Steering lock actuator (Steering lock ECU)
Click here
Steering wheel cannot lock (after connecting intelligent tester to DLC3, starting engine, Data List certification ECUs item Lock/Unlock Receive data is read, and steering lock command reception records display is NO).
1. Entry and start system (for 1AZ-FE)
Click here
2. Entry and start system (for 2AZ-FE)
Click here
3. Entry and start system (for 2AD-FHV)
Click here
4. Entry and start system (for 2AD-FTV)
Click here
5. ID code box
-
6. Instrument panel junction block (Main body ECU)
-
7. Certification ECU
-
8. LIN communication line
Click here
← PROBLEM SYMPTOMS TABLE (Nov 2005 – Dec 2006)PROBLEM SYMPTOMS TABLE (from Aug 2007) →